I actually own both intakes, so I'm trying to decide which one to put on my new motor. I may later this summer swap intakes and compare
So here's combo:
359w (40 over)
10:1 cr
X303 cam (286/286, 542/542)
800 cfm carb
Mildly ported victor jr heads (2.05/1.60)
1.6 roller rockers
1 3/4 long tubes
5 speed
4.10 gears
I plan to set max rpm about 6500.
The victor jr ports are a bit smaller than my head ports, the super victor is basically the same size as my heads, super victors match up better.
I was jus worried that the super victor would suffer too much down low.
Which would yield the quicker et at drag strip?
So here's combo:
359w (40 over)
10:1 cr
X303 cam (286/286, 542/542)
800 cfm carb
Mildly ported victor jr heads (2.05/1.60)
1.6 roller rockers
1 3/4 long tubes
5 speed
4.10 gears
I plan to set max rpm about 6500.
The victor jr ports are a bit smaller than my head ports, the super victor is basically the same size as my heads, super victors match up better.
I was jus worried that the super victor would suffer too much down low.
Which would yield the quicker et at drag strip?
