1st of all, I searched.
Now, I have read the hayes and chilton books about adjusting the throttle valve cable on an AOD. It says to do the following:
Disconnect the TV cable from the throttle linkage.
push the white lock pin up with a screwdriver
Make sure the block sildes freely
push the throttle all the way against its idle stop.
Reconnect the throttle cable to the throttle linkage, the pin sildes back into place locking it in the right position.
The book also says that AOD's from 90 on do not require adjustment using a pressure guage.
This website http://www.txchange.com/aodadj.htm
Goes through a multi step process of flooring the accelleartor, marking the TV block, measuing 5/16 inch and marking again, then marking a mid point and setting the cable just over the mid point.
Which is the right way?
Is it true that my 91 AOD does not require an adjustment using a pressue guage?
Please help.
Thanks
Paul
Now, I have read the hayes and chilton books about adjusting the throttle valve cable on an AOD. It says to do the following:
Disconnect the TV cable from the throttle linkage.
push the white lock pin up with a screwdriver
Make sure the block sildes freely
push the throttle all the way against its idle stop.
Reconnect the throttle cable to the throttle linkage, the pin sildes back into place locking it in the right position.
The book also says that AOD's from 90 on do not require adjustment using a pressure guage.
This website http://www.txchange.com/aodadj.htm
Goes through a multi step process of flooring the accelleartor, marking the TV block, measuing 5/16 inch and marking again, then marking a mid point and setting the cable just over the mid point.
Which is the right way?
Is it true that my 91 AOD does not require an adjustment using a pressue guage?
Please help.
Thanks
Paul
