Ford Mustang Forums banner

Spec 2 Clutch & Pressure plate for T5

510 views 9 replies 3 participants last post by  bikeboy587  
#1 ·
I have the Spec 2 clutch and pressure plate from my car I ran last year. Only 9,000 miles on it. Clutch did not chatter and worked awesome, I built a new motor and upgraded to a 3 this year. This is for a T5 with a 10 spline input shaft.

Part # is SF482

$100 OBO plus shipping
 
Save
#5 ·
Will this work with stock cable, pedal, quadrant, etc? I have a mostly stock 94 gt that I am putting a 3.73 gear in when I do the clutch. Is this too much clutch for an otherwise stock gt? how much (percentage wise) would you say is left in this clutch? Thanks.
 
#6 ·
I'd say there is 70% or more left on this clutch depending on how your drive. It is rated at 567 lb tq. It is way overkill for a mostly stock GT, at most you need is a Spec 1. But yes this will work in your car, just more than you need. But if you want it your welcome to it.
 
Save
#7 ·
so is more than you need a terrible thing? would it make the pedal extremely stiff? I just don't want to put cheap china crap in that I will have to replace again in a few k miles, but I can't afford a brand new spec 1 or whatever. I think they run around 300 bucks don't they?
 
#8 ·
yes they are over $300 new. Yes this clutch, as with any aftermarket clutch is stiffer than stock
 
Save
You have insufficient privileges to reply here.