Ford Mustang Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
718 Posts
Discussion Starter #1 (Edited)
I have a dynamic mighty mite c4 modular setup I want to get rid of. It is fully rollerised, billet servo, reverse manual valve body with built in t-brake, ptc 3600 stall, sfi modular bell housing, 8 bolt flex plate, and drive shaft to fit a 99-04 car. Basically everything other than the shifter needed to put it in a modular car.

Edit: I found out that it is not an x6. It is the M2. It is out of the car now. It needs to be freshened up. It will drive fine but slipped a little under hard boost in my car. I need this thing gone. $1500 for everything.





shoot me a text at 601-596-6687
 

·
Registered
Joined
·
718 Posts
Discussion Starter #4
Needs to be freshened up again. BUT, i need it gone. so $1500 needing refreshing or $2000 refreshed. It still runs and drives fine but slips under hard boost. Need it gone asap. This stuff new is over 4k
 

·
Registered
Joined
·
217 Posts
Needs to be freshened up again. BUT, i need it gone. so $1500 needing refreshing or $2000 refreshed. It still runs and drives fine but slips under hard boost. Need it gone asap. This stuff new is over 4k
What kind of power was being put through it? also any pics of the setup? Thanks

Drew
 
1 - 8 of 8 Posts
Top