Ford Mustang Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
397 Posts
Discussion Starter #1
I was wondering if anyone knew if a DF centerforce that I have with my rebuilt stock T5 will work on my Tremec. I've been told both that it will and that it won't because of the splines on the input shaft.If anyone knows could they please help, THANKS.
 

·
Registered
Joined
·
4,142 Posts
the spline count on the input shaft of the t5 and 3550 are identical. Your centerforce will work fine. It's the tko that has a different spline count and requires a different clutch disk.
 

·
Registered
Joined
·
3,788 Posts
I'll be swapping my T5 for a 3550 this weekend...from all of my reading I hear its basically a identical swap out (minus the crossmember)
 

·
Registered
Joined
·
4,142 Posts
one of the 3550 wire connections is way off compared to stock location, to make it fit, pull the wire out the trans tunnel, you should be able to get enough slack to make it work.
 

·
Registered
Joined
·
397 Posts
Discussion Starter #5
killer!!!! Thanks for your replys I was hoping that I could, but I wanted to know before I pulled the tranny from my GT just to get my CF.
I have a king cobra that came with my set up so I'll put that back in my GT.
 
1 - 5 of 5 Posts
Top