Ford Mustang Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
480 Posts
Not sure about the Cobra R pan, but I know Canton makes a pan for the Cobra...it may be the same piece.

I was checking out your car...you have a SHM motor and a Vortech and still run a T45?? Man, hows that thing holding up??
 

·
Registered
Joined
·
71 Posts
Discussion Starter #3
i looked at the canton site...

looks like it is the same.
good news!
there is a different windage tray for the 5.4, or one that fits both, so hopefully it has the one that fits both...

the signature is a little premature, I've been running with the vortech for awhile, but the shm shortblock/blower cams/heads/headers are in the rocess of being assembled. the trans will be the next thing to go, i'm sure, though i'm only pushing 6 lb of boost (pre-mods).
 

·
Registered
Joined
·
56 Posts
I really like those stripes. Where'd you get them done and how much, if you don't mind me asking. I think some nice guardian blue stripes on my white Cobra would look pretty sweet.
 

·
Registered
Joined
·
654 Posts
GOROBGO said:
anyone know for sure?
No, but the Canton pan and windage tray for the 4.6L engine are on my 98 Cobra.
 

·
Registered
Joined
·
71 Posts
Discussion Starter #6
i used to be able to say that MOST of the work...

...was done to the car before i bought it. now, with the new motor, i guess i can't really say that...

it was already striped when i got it, so i haven't a clue except somewhere in so. cal.

i won the auction for the pan. 250 bux!
he had it on his '98 4.6l cobra, so i think i'm ok!
:D

thanks for the replies!
rob
 
1 - 6 of 6 Posts
Top