Ford Mustang Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4,560 Posts
Configure the controller to give you a linear output and then check the voltage in tunerstudio looking at the "all channels" tab in the real time display section. You can see the egoV and egoV2 which are the voltages.

If you aren't reading any voltage check the connections first.

If you can read voltages just fine but that sensor is always showing full rich, you probably just need to replace the sensor.

If you did actually need a whole new one I'd probably get a 14point7 unit because I want to try one and they have some that look small enough to mount the controller in the MS case.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top