Ford Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
626 Posts
Discussion Starter #1
i need to make a new line for my 94 gt, its the low pressure line that goes from the cooler to the back of the pump. each end hooks to a barb and is held on by hose clamps. will heater hose work? i read somewhere its not made to resist oil, will the clear nylon reinforced stuff from the hardware store work?

also the p/s system is dry, is there a way to bleed it, or just fill it up and keep adding when it gets low?
 

·
Registered
Joined
·
1,361 Posts
Most auto parts stores sell a hose made specifically for low pressure power steering and transmission cooler connections. If your system is dry, fill the reservoir, start the engine, and slowly turn the wheel from full left to full right several times. This will work out the air the has entered the system. Be sure and check the reservior and top off as necessary. I hope you haven't run the system dry for too long, that will burn up the pump.
 
1 - 2 of 2 Posts
Top