Ford Mustang Forums banner

Take a look at my new MW 8.8!!

609 views 7 replies 5 participants last post by  yugnat'00GT 
#1 ·
Mark Williams Enterprises 8.8 with Wilwood brakes. Looks evan better in person!







 
See less See more
4
#3 ·
Eaton Posi with 800 lb pre-load spring, billet main bearing caps, 31 spline Masterline axles, 9" ends, MW bearings, 3.73 SupraFin Richmond gears, TA/MW cover, billet yoke, housing narrowed 2", Skinny Kid billet coil-over mounts, cut-off quad mounts, 3-1/2" studs, and that's about it unless I'm forgetting anything.

Wilwood kit is for 9" big bearing, 12-3/8" vented rotor, billet 4 piston Dynalite caliper, crossdrilled and slotted, all safety-wired.
 
#6 ·
Do yourself a favor before you put it in, weld up the axle tubes to the center housing. No reason to put all that money and effort into it and leave something like that alone and have it ruin the housing.

Bill
 
#8 ·
Mustang92 said:
Do yourself a favor before you put it in, weld up the axle tubes to the center housing. No reason to put all that money and effort into it and leave something like that alone and have it ruin the housing.

Bill
They are fully welded all the way around as well as the shock mounting brackets - pretty nice looking welds too.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top