Ford Mustang Forums banner
1 - 2 of 2 Posts

9 Posts
Discussion Starter · #1 ·
Has anyone installed either the SHM 318 stroker or the
ModMax 990-25300
3.552” (std) bore Stroker Kit with low compression (9:1 to 9.5:1)?

Just wondering as i'm gonna buy another 2V block and was thinking of putting either one of the those 2 stroker kits in. I'm also going to put a set of DTA's 2001 Headswap heads on, and Bullit intake from DTA, and a set of regrind cams, and probably a 150shot of nitrous, and a paxton / vortech Sc'r in the future. will the stroker kit be able to handle the nitrous and the Sc'r when there both combined?

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.