Ford Mustang Forums banner

Serpentine Pulley Alignment/ Vortech Supercharger

3710 Views 3 Replies 3 Participants Last post by  Secretariat
Hey all,

CAR: 03' Mustang GT, Vortech V2-Si, Built 4.6.

I was curious if anyone know's any tricks to checking the alignment of the pulley's on a Vortech Supercharged GT. My serpentine belt was chewed up pretty badly, and I would like to make sure that all my pulley's are aligned.

Secondly, does anyone know the correct length of the belt that I should buy to replace it? I've heard a 112.5" belt is correct, but I would like to confirm this.


1 - 1 of 4 Posts
Are you running a single bolt tensioner?? Bc that length sounds about right for a 3 bolt.

Sent from Free App
indeed, i specifically recall using a 112.5" belt on my combo...113" was just not "quite" snug enough
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.