Ford Mustang Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
293 Posts
Discussion Starter · #1 ·
Has anyone used the ROL head gaskets like they had on display at the WFC 5? Not sure the part #, but just seeing what everyone thought of these. I am putting a set of aluminum heads on this week or next and they said at the show that these don't rub a groove in you aluminum heads.

Thanks Travis
 

·
Premium Member
Joined
·
4,247 Posts
I like them alot...

I used them on my p head motor in my sig...held up very well. I bought a new set for my afr 185 r block 347 in my sig.....put them on last night. I bought them at wfc last weekend...very nice gasket for $40 a pair. They offer 2 thickness....think 37 and 45 thousandths.
 

·
Premium Member
Joined
·
4,247 Posts
I have gotten mine in the past...

from ed curtis at flowtech induction......but ROL has a website where they list their dealers....few autopart chains carry them..just none in my area.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top