Ford Mustang Forums banner

Rear main seal

Jump to Latest Follow

1 - 3 of 3 Posts
1black00gt

·
Registered
Joined
·
274 Posts
Discussion Starter • #1 •
Doing a clutch replacement and want to change my rear main seal. Is the Felpro any good or should i just buy the Ford one? Need the slinger too but don't know the actual name of the part or part number. Any input would be appreciated Thanks!
 
a-fast-crown-vic

·
Registered
Joined
·
447 Posts
#2 •
I think I used a felpro on mine. I am pretty sure they make gasket for oem anyways .
 
SilverSmith82

·
Registered
Joined
·
9,974 Posts
#3 •
The Fel Pro is fine. If the seal is dry I'm not sure I'd mess with it...
 
1 - 3 of 3 Posts
Recommended Reading
Read More

  1. Re-install steering column

    GT & SOHC
    I had to move my steering rack forward to install new control arms and now I cannot slide the column back into the rack. Any help? I did align it and try to slide it over but would not move.This is as far as i can go before hitting the imprint.

  2. Engine Builders

    GT & SOHC
    So I’m looking at ordering a built shortblock if I can’t find a shop to use/I like once I move to San Antonio this month. What online builders have you used that you’re happy with? I’m going to absolutely avoid MMR as there are just too many negative reviews on them. I’ve been looking at...

  3. New Edge On3 Single Turbo Return Line

    GT & SOHC
    I picked up a new edge with an On3 (single turbo) kit installed on it and I'm currently replacing the engine. I noticed that the drain line for the turbo is going to the front of the oil pan and the line goes below the oil pan fitting a bit before finally terminating. It looks like PO was...

  5. Speedo won't read.

    GT & SOHC
    After installing an aftermarcket steering wheel the speedo quit working. Deleted the horn/cruise control. Would the new wheel cause the VSS to fail? All wires are capped and tucked away. I also got rid of the radio.(radio harness isn't plugged into a radio is all.) -Thank you in advance.

  6. 97 MUSTANG GT ENGINE SWAP FROM 2011 CROWN VIC PI QUESTIONS

    GT & SOHC
    I recently decided to swap the engines due to a thrown rod. I am swapping with the 2011 crown vic PI but ran into an issue... The fuel rail on the crown vic has 1 connector and the mustang has 2.. is there any way around this so I could use the flex fuel from the crown vic? The injectors are...
Read More
About this Discussion
2 Replies
3 Participants
Last post:
SilverSmith82
Ford Mustang Forums
A forum community dedicated to Ford Mustang owners and enthusiasts. Come join the discussion about performance, production numbers, VIN decoders, modifications, troubleshooting, power adders, DIY tutorials, and more!
Full Forum Listing
Explore Our Forums
5.0/5.8 Engine Tech Lounge General Mustang Tech Windsor Engine Parts GT & SOHC
Popular Communities
Community avatar for Home Entertainment
Home Entertainment
1,280,000+ members
Join
Community avatar for Mountain Bike Reviews
Mountain Bike Reviews
450,000+ members
Join
Top