Ford Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
113 Posts
Discussion Starter #1
To whom may be able to help:
I'm replacing the badly rotted floor pan sections where they meet the front of the rear fender well and inside rocker on my '86 Capri. I purchased the entire $450 '87 to '93 rear pan section to cut panels out of to replace my cars rotted sections. The rear panels that I have cut fit good except there is a 1/4" gap between the fender well and the pan...
From the factory, was the inner fender spot welded to the floor or was that gap just filled with seam sealer? Perhaps the '87 and up cars had larger rear fenderwells?`
 

Attachments

1 - 2 of 2 Posts
Top