Ford Mustang Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
268 Posts
Discussion Starter · #1 ·
im still learning bout the stang an its a slow process but i have a question for you guys.

when porting.. i always see pics of smooth lines from the work i have seen, but what would happen if it was milled in like a thread pattern along the inner walls? would this give the air more of a twist and increase flow any... has this been tryed? im just curious because i have never seen anything different then thhe normal port job
 
1 - 1 of 1 Posts
Top