Joined
·
9 Posts
Building a 408 street car. Was looking g at putting on a budget turbo setup, (one single kit) but in the add it says you have to run mass air.. Can someone tell me why you HAVE to run mass air??
On3 mass air question
1 - 1 of 1 Posts
1 - 1 of 1 Posts
Join the discussion
Recommended Reading
-
Valve springs and head studs necessary?
TurbochargersHi guys. I'm building my first turbo car. My intent is to turbo a bone stock '94 GT minus emissions equipment. I'll be installing a larger in take pump, blow thru MAF and 80lb injectors. I've read and heard that I should run head studs and better valve springs in the E7 heads. I've also read...- 43
- 1K
-
2.5L stroker 93 coupe Dyno GT35
TurbochargersHere's a video of my car on the dyno. Scroll 3/4 of the way thru to see the pull. I was letting it warm up on the dyno and my friend started filming a little early. I was surprised by the power as you can tell.- 14
- 940
-
Mustangmichael · updated
-
Turbo Build Help - 331 Stroker w 78/75 On3 Turbo
TurbochargersI searched through the forums and couldn't find a post that really answered all my needs so hopefully this doesn't break any rules and sorry if I do but I am in highschool and I'm new to building cars. I am getting started to build a 331 stroker turbo build that's mainly a street car but I will...- 32
- 2K
-
On3 header size??
TurbochargersDoes anyone know the header size on the on3 turbo kit? Are they 1 5/8?- 1
- 345
-
HETHENS408 · updated
-
vortech v1s to On3 single turbo
TurbochargersHey everyone i have a question, hopefully someone here might have the answer. So right now i have a 1990 lx with a 331 forged internals with a stock block, edelbrock performer rpm heads, vortech v1 S trim 8lbs boost. Fuel sys consists of 42 lb inj, Ford lighting mass air, 255 walbro intank...- 6
- 500
-
90convert · updated
Join now to ask and comment!