Ford Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3,065 Posts
Discussion Starter #1
Hi all,

I am going to be installing a Detroit C-Locker soon.... and was wondering.... if I should go ahead and weld up my axle tubes and also weld my torqueboxes up... probably using a UPR or Wild Rides kit.

Here's the deal.. I have a maximum motorsports Heavy Duty Torque Arm and Panhard bar on the car. When welding the axle tubes...do I just need to weld the tubes to the pumpkin and that's it?

Also..... Since I have the Torque Arm/PH bar... do I need to strenghten the torque boxes by welding them up...and/or installing the UPR or Wild rides torque box kit for my lower control arms? (There are no upper control arms in use with a TA/PH bar setup).

Any input would be greatly appreciated!

THanks,

SOHC
99 Vortech GT
89 LX 5.0 Vert
02 F150 SuperCrew
 

·
Registered
Joined
·
3,065 Posts
Discussion Starter #2
Nobody>?

SOHC
 
1 - 2 of 2 Posts
Top