is the motor level in the car ? the only other thing I can think of is would lower motor mounts give you the clearance you need ? might be easier than send the headers back... If I recall you can get 3/4 of a inch with drop mounts..
Mac 351w longtube headers hit floor board
I mocked up my drivetrain and found the pass side collector hitting the floor board. Driver side looks fine. When I measure the collector height from the ground, the pass side sits up 1" higher, which is causing the floor board interference. The headers are 1 3/4 Mac longtubes on a 351w with convertible mounts. I also bolted up the headers with the engine block and heads on the stand - the collectors are still uneven by the same amount. Anyone else have this issue?
1 - 1 of 33 Posts
1 - 1 of 33 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Ford Mustang Forums
A forum community dedicated to Ford Mustang owners and enthusiasts. Come join the discussion about performance, production numbers, VIN decoders, modifications, troubleshooting, power adders, DIY tutorials, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
