It has a few of the ports "offset" just a little bit maybe 1/16 of in maybe i installed them wrong. Upside down?? I put the little o rings twards the intake flange...
intake gasket problem. need advise!!
Doing a hci swap on my 89 gt. Trick flow 170s, stage 1 came, trick flow valve train, performer 5.0 intake. My problem is the intake gaskets wernt matching with the intake ports the way i would like them to. (Fel-1250) im real particular and its not off by much, but if it has any problems in the future ill revert back to not fixing this hahah. Can i trim these? And what is the easiest way to do that? Thanks in advancw for the help.
1 - 3 of 6 Posts
Thanks!! I didnt even think about that!!
1 - 3 of 6 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Ford Mustang Forums
A forum community dedicated to Ford Mustang owners and enthusiasts. Come join the discussion about performance, production numbers, VIN decoders, modifications, troubleshooting, power adders, DIY tutorials, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
