I'm trying to install a set of 3" Moroso wheel studs (#46185) into a pair of Advance Auto replacement sn95 wheel bearings/hubs... do I need to drill these out to fit these studs?
I don't think the 'knurl' of the studs are going far enough in, the splines still have a ways to go before contacting the hub. I have the stock studs that came in the old/stock hubs and they are the same, while the new Advance Auto studs will slide right in to the start of the splines. Maybe the replacement hub & studs combo uses a smaller knurl? so I'll need to open them up to .580", which is a 37/64" drill bit?
This is an older thread, you may not receive a response, and could
be reviving an old thread. Please consider creating a new thread.
Ford Mustang Forums
A forum community dedicated to Ford Mustang owners and enthusiasts. Come join the discussion about performance, production numbers, VIN decoders, modifications, troubleshooting, power adders, DIY tutorials, and more!