installation of Moroso wheel studs into sn95 hubs

I'm trying to install a set of 3" Moroso wheel studs (#46185) into a pair of Advance Auto replacement sn95 wheel bearings/hubs... do I need to drill these out to fit these studs?

I don't think the 'knurl' of the studs are going far enough in, the splines still have a ways to go before contacting the hub. I have the stock studs that came in the old/stock hubs and they are the same, while the new Advance Auto studs will slide right in to the start of the splines. Maybe the replacement hub & studs combo uses a smaller knurl? so I'll need to open them up to .580", which is a 37/64" drill bit?

Thanks.