Ford Mustang Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
87 Posts
Discussion Starter · #1 ·
I need to index my drveline after a gear install to get rid of a noise/vibration at 90-110 MPH. I didn't notice any paint marks on the thing when I took it apart, but then again I wasn't really looking for any. What is the best way to go about getting this thing set up right? If I can't get rid of it after these attempts I'll end up going with a different driveline.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top