[dean-93]

what parts are needed to make vortech oil lines (thread size,diameter,angle, male female)

i dont want to buy the expensive vortech kit i want to make them myself

might do a small oil cooler ,what do you think?



gota v1 s-trim

 

[midnightrider]

Parts for oil feed line(Not lineS). 90* flare, 45* elbow, 1/4 tee, 3" nipple 1/4 X 25" oil feed hose, 1/8" NPT -4 x 45* male elbow, 1/8" NPT straight fitting, 2 #4 swivels x 1/4" hose barb fitting. That's all that comes in their "Oil feed" kit other than 2 .500 ferrules...The simpliest thing to do IMO is buy an Appx 25" 1/4" steel braided brake line & 2 fittings(1 1/18" NPT straight & 1 45*) Drill & tap the oil log behind the oil sending unit. That's how I do them & cuts down on the connection & number of places tha can leak or potential for....

 

[spydermandb]

Sounds to me that your trying to save a buck is going to cost you lots of time and money anyway....

 

[95cobraguy]

1/2 way down the page are all the oil feed and return items u need.

http://superchargersonline.com/accessories.asp

 

[S-Trimmed302]

You simply need a section of -4 Braided line,one Straight #4 Fitting and one 45* fitting.VERY easy to make and you can make it relatively cheap.