Ford Mustang Forums banner
Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Have a 2.3l build motor it is as of right now a short block. Head is ported stock valves and springs.
asking..$3,500 pieces assembled price is negotiable have $4,000 in parts alone. please serious buyers only contact for pics and any info.


Bottom end
*2.3l block
*Magnafluxed
*zero decked
*line hoaned
*.20 over bore
*federal mogul race bearing
*Melling pump
*Hardened oil pump drive
*Crower 5.700 rods
*JE Forged pistons .20 over w/total seal rings
*ARP Main studs
*ARP Head studs
*full float rod
*cometic head gasket
* 9.1 compression
*Balanced rotating assembly
* blueprinted
*stock crank

Cylinder Head
*Professionally ported by Engine builder at Cunningham Motorsports
*Stock valves and springs
*stock cam
*ported intake manifold

Pick up only will assemble as long block or will split and sell seperate. located in spring city,pa 19475

20 years of Automotive experience own my own performance shop check me on facebook @ Decordre Automotive and performance.
email me or serious buyers contact shop 610-948-4445
Brandon Decordre
 

·
Registered
Joined
·
108 Posts
Willing to split? More info on the head porting if so.
 

·
Registered
Joined
·
108 Posts
the head, any idea how much porting is done?
what it flows etc
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top