Ford Mustang Forums banner

1 - 9 of 9 Posts

·
Registered
Joined
·
127 Posts
Discussion Starter #1
Ok, I shall explain later, but I am in dire need for this info:

What EXACT bolts to bolt the tremec to the bellhousing with? I need to know which 4 bolts to order, ASAP.

Thanks in advance corralers!!!!!!!!


-Jacob
 

·
Registered
Joined
·
7,030 Posts
Hardware store Grade 8
about 2" long not sure about size though

Tim
 

·
Registered
Joined
·
127 Posts
Discussion Starter #5
Yeah....looking for the specific bolt size/thread actually.

Anyone know the specs???

I need to get these ASAP!
 

·
Registered
Joined
·
7,030 Posts
Can you take the bellhousing to the hardware and mach it up?
I know that it is standard thread about 7/16" or 1/2"

good luck

Tim
 

·
Registered
Joined
·
127 Posts
Discussion Starter #7
Well, I would...but it's still in the car. I used standard thread (I think it was a 7/16", know I used Grade 8) and they are BROKEN. My tranny is held in by ummm....the tranny mount now. Yeah, not good. So it looks like I'm going to need to helicoil some stuff...and get some new bolts...and it's not really cool.

Anyone have the specs? Thanks!!!!!
 

·
Registered
Joined
·
254 Posts
Well I dont know if this will help but if you broke the bolts then you will have to remove the tranny anyway so just take it off and back out what remains and take that to the hardware store. ARP does make a good set but a grade 8 should hold up to anything. On the T5 its a 7/16" cap screw. Maybe its the same for the Tremec.

Allen
 
1 - 9 of 9 Posts
Top