Ford Mustang Forums banner
1 - 1 of 1 Posts

· Registered
32 Posts
Discussion Starter · #1 ·
I am WIP on a "club" engine harness for a Fox Mustang with EEC4 & EDIS8.

I am finalizing plans for the power distribution and would like a sanity check; specifically on diode polarity. The factory EVT Manual doesn't show diode protection on any of the relays, so no help there. I am confused on the fuel pump relay if I'm trying to protect the "EEC pin 22" or the "EEC Relay / EEC Pin 37/57 Bus" from flyback. Wiring Diagram below:

Any thoughts?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.