Ford Mustang Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Need some help here. I have a coyote with a terminator x max ecu. Cts is reading low error. I feel as if if tried everything under the sun and I can’t seem to trouble shoot this. I’ve checked for continuity, ensured I had good grounds, attempted to jump the plug using a paperclip and changed out the sensor. After giving Holley this information they insisted I attempt to go through the setup wizard again and also update my firmware, to which all methods were inconclusive. Any help or opinions is much appreciated.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top