Ford Mustang Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter · #1 ·
Trick flow stage 1 cam (.499/.510---221/225dur). Using ported E7's with stock valves and Felpro .039" gasket. Getting ready to have a valve job and was thicking about milling the heads as well. Anyone running anything similar in lift/duration with milled heads(how much?) with piston/valve clearance problems? Would it be safe to mill them a little .050"/.100" and still be ok? I can check the clearance before the valve job to see what I have but I was wondering if someone else could tell me how much milling they've gotten away with with similar setup.
Thanks
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top