Ford Mustang Forums banner

Cam Position Sensor. How do I sync ?

663 views 3 replies 3 participants last post by  Mustang5L5 
#1 · (Edited)
Hello
i just put in a .630 lift camshaft and i didnt think to mark the cam sensor spot.
How do i re-sync ?
 
#2 ·
I think i did it right...but most likely not because the car still wouldnt start.
Cam Position Sensor looks like this:
cps1.jpg


And this is where i rotated the crankshaft to about 26 degrees ATC i think. :
cps2.jpg


I rotated the crankshaft 180 degrees but it put the half-moon of the sensor on the other side so i put it back where it was and it still didnt start.
.Maybe i need the half moon on the other side.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top