Ford Mustang Forums banner
1 - 2 of 4 Posts

·
Registered
Joined
·
57 Posts
I used the hooker slip tube swap headers and they fit perfect with only a slight modification to the pipe that wraps around the steering shaft :hammer: With an aftermarket shaft im sure it would have fit w/ no modificaiton. Basically I bolted the passenger side up, set the drivers side in the engine bay, got the trans deep in the tunnel then brought up the drivers header, bolted it up and slid the engine/trans the rest of the way in. Kumar :lol: :lol: :lol: :lol: :lol: :lol: :lol:
 
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top