Ford Mustang Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
158 Posts
Get a multimeter and test:

1) Continuity (mechanical integrity) - move the wires around and if you get a continuity (short), replace it

2) Excess resistance - wires are rated in ohms per foot, usually in the 1000 ohm range for suppression wires

This is the best way to truly test them - toer than that, most of the claims for wires are baloney - if they conduct enough juice to jump the gap, thicker wires, fancy names, etc will not enhance perf at all
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top