Ford Mustang Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
109 Posts
Have done this many times. Simple process, but like stated be careful for the brake lines. Also make sure that the bolts on the control arms are torqued when the vehicle is sitting on the ground. If not the bushings may be loaded incorrectly.
 

· Registered
Joined
·
109 Posts
Yeah, it could be tight. I was able to access mine from crawling under from the rear. If the car is on jackstands under the axle and the front was raised a little you will be fine.

You should be able to unplug the sensor. The wire is about 12" long. If you can follow the wire for that length it should lead you to the connector.

Good luck
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top