Ford Mustang Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1,640 Posts
Discussion Starter · #1 ·
I just bought an aluminum driveshaft off of EBay. It's used with about 10K miles. Can I just bolt it right up or do I need to have it balanced?

Thanks,
Henry
 

·
Registered
Joined
·
1,640 Posts
Discussion Starter · #3 ·
Thanks for the quick reply. Here's another question. When you say replace the u-joint, are you talking about the joint that's on the driveshaft?

Thanks again,
Henry
 

·
Registered
Joined
·
323 Posts
Mine bolted right on. I checked with Summitt about the balancing, and they said it was not necessary. The directions in my Chilton's book were pretty decent for the install. Was a pretty quick & easy job.

Good luck!
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top