Ford Mustang Forums banner

96+ spindles on a fox

8185 Views 27 Replies 16 Participants Last post by  Mustang5L5
I've read so much different info that I'm not sure what to think.

I purchased 97 Gt spindles, hubs, brakes. I want to install them with 00 mustang GT wheels. They are 17x8.

Will I need a bumpsteer kit to get the toe back in line?

Is anyone else using these spindles on a stock k member?

Any input?

BTW my car is an 89 5.0
1 - 2 of 28 Posts
I can tell you that MM recommends you use 96-04 spindles with their aftermarket K-Member. I've already talked to them about it.
No where in his post did he say he has an aftermarket K-member. I was giving him a resource to educate him on the issue, rather then be spoon fed the information. You know, give a fish, fed for a day, teach to fish, lifetime.
I don't give a damn. What you said had nothing to do with what I was telling him from my point a view as I wasn't paying attention to your post. I was telling him what MM told me when I talked about it with them a while back.
1 - 2 of 28 Posts