Ford Mustang Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
332 Posts
Discussion Starter #1
I wanted to mock all this up before painting the engine bay. I moved the A/C condenser into the core support like the 96+. 96+ radiator and mounts with 99-04 ABS and 03 Cobra Hydroboost/pedals. Mostly straightforward, but time consuming.
 

Attachments

·
Registered
Joined
·
332 Posts
Discussion Starter #3
It's funny that you mention that . What little bit of bushing that was left melted when I welded the pedal assemblies together.
it would be a good time to inspect and replace the clutch shaft bushings

they are plastic
 

·
Registered
Joined
·
332 Posts
Discussion Starter #5
Thank you. I'm having a hard time finding info about combining the EEC harness and A/C.
Looks good. I did this also when I swapped a 2v and IRS into my 89 notch.


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
923 Posts
Thank you. I'm having a hard time finding info about combining the EEC harness and A/C.
I ended up using all the wiring from the 97 car, including the Hvac box, fuel system and all the lighting.


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
332 Posts
Discussion Starter #7
I see. I want to keep the fox dash, so I'm not sure where to tie in some things between the 89 dash harness and the 98 EEC harness.
I ended up using all the wiring from the 97 car, including the Hvac box, fuel system and all the lighting.


Sent from my iPhone using Tapatalk
 
1 - 7 of 7 Posts
Top