Ford Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hi I have 1973 351W block, a 4.0" crank ,Eagle H beam rods. Je 4.060 pistons and the Cleveland 2V heads and The Edelbrock intake. with a 750cfm Holley carb. What is the estimated H.P of this?? Its going into a 79 Mustang.It has taken 2 yrs to gather the parts now its time to build it, Finally. Is there any thing I should watch out for? any tricks I could do? anyone done one of these clevors? Thanks for any info. Cheers Rob
 

·
Registered
Joined
·
5,967 Posts
You should post this in the tech section and not a vendors section of which you are using none of their parts. Just a thought. Top of the main page 5.0/5.8 tech

FordStrokers is a company.
 
1 - 2 of 2 Posts
Top