Ford Mustang Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
83 Posts
Discussion Starter · #1 ·
I have a 1969 351 (9.480 deck) short block and I was wondering if it is possible to use pistons designed for a late block (9.50 deck). I would thinks so because most gaskets are .041" thick and the difference is only .020". This assumes that the block has never been machined on its deck. Please help.

Stanman;)
 

·
Registered
Joined
·
83 Posts
Discussion Starter · #5 ·
Thanks guys. ;)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top