Ford Mustang Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
And you're gonna do the opposite with your after market tails I assume?
Cut the housing away from lense? That should work good, I'd seal them with 5 minute epoxy though. You can keep going over the joint until it's basically smooth and the stuff will just drop into every little air gap. Much cleaner than silicon or anything similar.

If you have a blow torch quickly pass it over the epoxy and it'll pop all of the air bubbles.(must be a torch of some sort, the carbon dioxide is what pops them not the heat.)

Post pics when you're done!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top