1997 Mustang GT 5 Speed with 113,000 miles runs 100% and sounds even better! New PA state inspection, ICE COLD A/C!! The Mustang is lowered 2 inch with aftermarket control arms and rear shocks, has OEM 03 cobra wheels on it that are in near perfect condition! I have a lot of time and money in this car and it runs perfect, unfortunately I have to sell to finish other projects, my loss your gain! For its age it is in good shape, but does have some flaw, the typical mustang seats that are tearing (driver side only), the steering wheel is pealing and It has a couple blemishes on the exterior also (scratches and a few dents), next to that it is perfect the paint shines and look almost new! Like I said I have a lot of money in it and have put a lot of new parts on within the last 3k miles, they include:
-New tires and alignment (275 REAR 245 FRT)
-New convertible top (PROFESSIONALLY INSTALLED)
-New brakes and rotors all around
-New ball joints
-Valve cover gaskets
-New power steering rack
-New tierod ends
-New BBK cold air intake
-BBK high flow mid pipe
-Flow Master 40 series mufflers
-Complete tune up (plugs wires pcv valve and ALL FLUIDS)
-Aftermarket shifter with cobra shift knob
I have most of the receipts for the parts listed and have documentation of repairs also. I'm not trying to ditch a POS if I could keep it I would but like I said I have to sell. My price is firm because I have well over that into it. The top alone was over $1000.00. If you would like to test drive you can contact me and set something up. ASKING $4,500 Easiest way to contact is phone 570-two33-one62two.
Thanks!
Bret
-New tires and alignment (275 REAR 245 FRT)
-New convertible top (PROFESSIONALLY INSTALLED)
-New brakes and rotors all around
-New ball joints
-Valve cover gaskets
-New power steering rack
-New tierod ends
-New BBK cold air intake
-BBK high flow mid pipe
-Flow Master 40 series mufflers
-Complete tune up (plugs wires pcv valve and ALL FLUIDS)
-Aftermarket shifter with cobra shift knob
I have most of the receipts for the parts listed and have documentation of repairs also. I'm not trying to ditch a POS if I could keep it I would but like I said I have to sell. My price is firm because I have well over that into it. The top alone was over $1000.00. If you would like to test drive you can contact me and set something up. ASKING $4,500 Easiest way to contact is phone 570-two33-one62two.
Thanks!
Bret
