Ford Mustang Forums banner
1 - 6 of 6 Posts

177 Posts
Discussion Starter · #1 · (Edited)
I started this project a while back around 2007 and have completely lost interest in it. Many good parts perfect to move everything over to Mustang.

Some key parts installed:

408w stroker kit, H beam rods (Eagle kit)
Engine Build by Doug at Fox Chase Machine shop in PA.
Custom Cam
Trick Flow Alumium Heads 170cc Redone by Fox Chase Machine shop
Trick flow R EFI intake
Quarter horse tuner (Dirty Dirty Racing did the initial tune)
Lightning mass air with 42 lb injectors
McCloud Steel bellhousing
Brand new Drag radials never used
Weld 15x8 on the rear, Weld 15x5 on the front
Steeda Tri-ax shift
Mustang rear 8.8 3.27 with 10"drums
All new stock mustang breaks on front
New balljoints
MM Caster Camber plates
CHE adjustable lower rear control arms
Powerpipe fender intake system
Hooker long tube headers
Custom H pipe and tailpipes
Mark VIII Fan with Fan controller
Sony Stereo with remote
complete leather interior, Porno red
Brand new windshield
Very little rust on her, clear coat in bad shape.. clean body needs paint.
Everything on Car works
124k miles on car
title in hand
more stuff I can't remember lol

Drove car about 5 miles and parked it in storage garage, car needs a front alignment. I would think towing it to new location would be better than driving. Its started regularly and stored on jack stands.

Perfect parts car for Foxbody Stang or just finish what I started. Looking for $5000 for everything, plus trunk full of parts. I'm planning on buying a new car in June so would like to have this gone by than.

Door is clean, picture looks like there's a dent but there isn't one.

177 Posts
Discussion Starter · #3 ·
Someone asked in text if I'm willing to sell just the 408 and Tremec 3550 and yes I am willing to do that for the right price. I would just would need cash in hand prior to taking anything apart. I figured anyone doing an engine swap would convert this back to 302 with their old parts and just sell it whole.. either way I'm flexible.
1 - 6 of 6 Posts