Ford Mustang Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 · (Edited)
1985 Mustang GT: Pro Street

- original 5.0 liter bottom end/crank/pistons w/modified top-end (202/160 intake/exhaust w/586 lift Crane Cam, double springs/World Products heads, two carbs available; original approx. 36,000 miles

- original, stock body except for glass hood w/cowl induction

- 10-pt roll cage, stock interior except for everything behind front seats, which is custom aluminum

- back-halved/box tube, narrowed Ford 9" large-tube housing, Moser axles, Koni coil-overs; rear end built for 8.8s/stock T5 trans, drive shaft

- braided fuel lines - shorty headers w/aftermarket cats and custom 3" exhaust exiting from rear

- 12-gallon Harwood fuel cell/no fuel guage pickup

- Mickeys front/rear w/ Centerline muted aluminum wheel - excellent race platform, but streetable w/all safety equipment retained

- $18,000.00 in described trim. Sold as race/show platform; uninspected (as is).

- SERIOUS INQUIRIES ONLY


Contact: Tom
[email protected]

 

· Registered
Joined
·
279 Posts
Wanted: Back halved or full chassied FORD racecar or Pro Streeter


Wanted: Back halved or full chassied FORD racecar or Pro Streeter. 79-95 Mustang, early Fairlane, Falcon, Comet, Fairmont or Zephyr fast back. Car must have room for minimum 13" x 30" slicks. Prefer finished car but will consider a project that is near completion.

Please email [email protected] or call 561-744-9448.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top