Listed is a 3" x 3" Dr. Gas Exhaust Crossover kit with Summit header collector, I intended to use this on a 1966 Ford Mustang (with headers). This should work on most 64.5-73 V8 Mustangs. actually since it is a cut and weld to fit solution it should fit most applications using a 3"...
Posted are exhaust components purchased for an early model Mustang Exhaust system (excluding the mufflers), I intended to use this on a 1966 Ford Mustang (ideally with headers). To the best of my knowledge, this should work on most 64.5-73 V8 Mustangs. Add your own favorite...
SOLD: Pypes Stainless Off-road X-pipe for 86-93 5.0 with Shorty Headers
Pypes 409 Stainless Off-road X-pipe for 86-93 5.0 Mustang/Capri with shorties. 2.5". Was used for about 1500 miles, but going with a different setup on my car. Works with all automatics and manual transmissions. Very good...
Car runs great, too fast for the teens in our house driving now.
NO body damage, just needs paint
Custom built: 302 Ford small block with racing chip.
T-5 short throw racing transmission.
Headers (2 1/2 " all the way out)
2 Stage flow masters.
BBK X-pipe for sale. It is for full length headers. It was in a 93 cobra with a T5. I have wire wheeled the entire thing since this picture was taken. $90.00 shipped, it is already in the box and ready to go.
Thanks for looking, Matt
Accufab Mustang Headers 302
I have a set of custom built Accufab Racing headers up for grabs.
For 302 based motor
1 3/4" long tubes
3" slip on collectors
Raised port flanges
3" bolt pattern (in line, but wider then stock bolt pattern)
Full pipe at head (does not crimp in square like...
Selling my 06' so I'm selling all the performance parts. I have a set of SLP Loud mouths with about 8k miles on them and a Pypes O/R x-pipe also with about 8k miles. SLPs: $200 shipped, $175 local pickup. Pypes: $145 shipped, $100 local pickup.
ALSO FOR SALE:
AMR Staggered 18" Charcoal Wheels...
Here's some exhaust parts i've got away in the garage that i no longer have a need for.
Any questions feel free to ask, thanks for looking.
NEW Flowtech Ceramic Coated Longtube headers $325 + shipping
- 1 - 5/8" primaries
- 3" collectors.
- These fit any Mustang 4V DOHC...
I noticed my 2.5" o/r h-pipe is restricted down to a 2" opening...what's the point in that?? I'm assuming to accommodate a wider range of connections. Anyway, can I grind the opening larger to 2.5"? Will I run into exhaust leaks if I do that?
I have a bassani SS off road x-pipe for sale. It came of my old 01 cobra (5spd)and fit fine but while looking up the part number online for this post I found that pn 48-4600-2 is for a 99-04 GT with an auto. Never had an issue wit it on my old car( bought it with it on there). I took it off to...