Search Results for ‘shift’

Sport comp 5 inch tachometer, $290 new- $220 All my other gauges are for sale also, to include the center gauge pods. Florida 5.0 cluster will be sold as 1 item.

Not sure which fork this is but if you know how to replace it then I'm sure you know which one this is lol To reduce the shipping I will knock out the pin so the shaft and fork are in two pieces. $19 shipped

So i just got my 351w dropped into a notch coupe that came with a built c4 (shifter, bands, clutches and aftermarket servos). I have been breaking in the motor and enjoying the crisp shifts and the tranny worked fine. Then the other day i got on it hard while rolling and after that it stopped...

Bullitt Shift Knob out of my 01 Bullitt. Has a bunch of wear but still threads on fine. $19 SHIPPED Leather Wrapped Shift Knob out of a 1996 Cobra. Leather is showing some wear with a slight hole towards the front. Would make a good daily driver shift knob if you have a really nice original one...

SOLD!

................

I just bought a 1994 Mustang GT. Transmission was rebuilt 2K miles ago. While cruising anywhere between 35-65 it sometimes starts shifting up and down rapidly. I have done some searching and found it could be the IAC or the shifter position sensor (mlps?). I'm short on money after buying the car...

SOLD!

SOLD!

SOLD!

It's really weird, the check engine light comes on about 1 after I fully complete my shift. Like after 2nd or 3rd, whatever. But after or around about 3000rpm's, it shuts off and then comes back on again, I have no idea what's going on. I thought o2 sensors, but when it is in neutral the check...

Hey guys, love the forum and glad to be here but I have a question on an issue ive had for a while. I used the search feature to look for my answer first but the results dont seem like my issue. I have a 2001 Mustang GT vert with stock 5 spd trans,shifter, clutch, driveshaft, and gears. When I...

SOLD!

Lokar Shifter Boot Set - Polished Stainless - SOLD SOLD

Promotion has a cryo treated 3-4 shift fork for the T45, has anybody personally broken one, or seen one broken? Im debating on what to do with the next T45, and other than the 10 spline input shaft, that seems to be the weakest link. Plus mine is showing it's ass, I believe thats what it is...