Ford Mustang Forums banner

shaft mount

  1. Windsor Engine Parts
    1.7:1 intake and 1.6:1 exhaust. This are extruded material, NOT the "off the shelf" cast rockers from Harland Sharp. These are beefed up around the fulcrum, and lightened on the valve end. The extruded material is literally TWICE the strength of the cast material. They are not listed on the...
  2. Windsor Engine Parts
    Small block Ford Trick Flow R cylinder heads. Before I even get started, these castings have been repaired a few times. But as is normally the case, they have held up with no problems for several years since the last round of welding. Here’s the worst damage they suffered and this was back in...
Top