So out of general curiosity that I have for the science behind the design of connecting rods, their failure points and what really matters in a high revving, high HP application I ask, which rod would be better suited for a high RPM (10k+) N/A build?
A "Boostline" I beam rod rated for 10,000...
Brand new forged I-Beams, also selling new 4.6 DOHC forged pistons to go with. See my other posts. $225. Call or text 4O73Seven5o340
ModMax 4.6 Forged 5140 I-Beam Connecting Rods are an awesome choice for your high performance engine. These rods are meticulously manufactured to...
i have a question on checking connecting rod side clearance.
I believe the procedure is to push both rods all the way to one side. And have it touch the crank. Then use a feeler gauge to measure the gap to make sure it's in spec. my question is that after that is done do the rods need to be...
Started collecting parts for a build, but life said "nope" and money had to go another direction right now.
18cc forged pistons (standard bore), standard length forged rods with arp2000 rods- $500 shipped
Trick Flow cams w/ springs part number TFS-51802002 less than 100 miles. Installed right...
im installing new mains and rods in my 351w and the rod bearings are really loose in the rod they fall right out off the rod after they are installed,this motor only has 1k on it and i tore it down to change pistons for boost so these bearings look brand new still but im replacing them anyway...
I have a set of used Manley I-beam rods PN: 14120 that I am selling. These are not available through Manley any longer. These rods have the strength of 4340 forged steel with a lightweight design similar to a stock rod. Perfect for N/A high reving applications up to 500 horsepower where a...
I have for sale a New set of Lunati H Beam Rods. Changed directions with my build. My loss your gain. Specs Listed below. They are $425 to your door. NIB!
Bolts: ARP 187,000 lbs
Have a set of take out SVT Manley H-beam Rods out of a 2003 Cobra. Rods are in great condition. $425.00 Shipped. Rods will come with factory pistons as well (freebee) call 818-341-7223 ask for Bryan or email [email protected]
EDIT: $375 Shipped/Insured/Tracking #/Fees included to the Lower 48 to fund purchase of new other rods! Approximately 30 passes on the rods. Look to be SB1400 or SB1500 series based on specs.
As stated in the title, I'm looking to make a trade my:
-GRP Aluminum Rods
Set of brand new connecting rods for SBF. I bought them for a 306 I was building but life changes have necessitated their sale. They are Eagle model 5090FP.
They are 5.090'' length, I-beam, forged steel, press-fit, through bolt cap retention, ARP 3/8'' bolts, 12 point bolt heads, 565g each...
All the stuff I want in very good condition.. and its all for my 347
I would like a 28oz balancer, I need to be able to read the markings.
A nice flywheel
Cast 3.400 stroke crank
5.400 Rods (H or I beam)
.040 over pistons with Twisted Wedge valve reliefs.
Send me a pm with what you...
Started tearing down a motor.
Crank: Stock, first numbers are E7 (off the top of my head, ill verify tomorrow)
Pistons: e7ze-ca above trw (4 valve reliefs)
Rods: C80E-A A051 (I believe they're 289's) (still attached to pistons)
Stock Volume Oil Pump with pickup tube.
Stock Oil Pan