Ford Mustang Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-12 of 12 Results
  1. Maintenance
    I'm looking to complete the Foxbody fog light mod to reduce the load on the headlight switch. Searching various forums I'm finding old threads which refer to a good write up on the Corral at the following link: www. corral.net/tech/maintenance / foglights.html . This link does not appear to be...
  2. Electronics and Entertainment
    I bought a FK75 fan controller brand new a couple months ago. My '06 Jeep SRT-8 was running hot. I'd replace nearly every part of the cooling system, including several thermostats. I remembered my Fox Mustang days (I miss them), and how great my DC Controller was, so decided to give it a shot...
  3. S197 Mustang (2005-2010)
    4.6 GT, engine stumbles periodically on throttle tip-in. I get the CEL "engine" icon, plus the wrench icon lights up. Returns OBD code P068B which is: Engine Control Module (ECM) / Powertrain Control Module (PCM) Power Relay De - Energized Performance Too Late I presume there is a relay...
  4. General Mustang Tech
    One of my relay connector's wires is frayed. This is frustrating, to say the least. (I'm talking about the piece the connects to the constant control relay module (CCRM), i.e. this...
  5. 5.0/5.8 Engine Tech
    I have an '89 5.0 Mustang and for some reason the car turns over with battery connected and no key in ignition. Could this be a starter? Ground problem with wire from Solenoid to starter? I have just replaced the solenoid and still have the same problem. Perhaps the little black relay is bad? If...
  6. EEC Tech
    hello, I have a 1990 hatchbatch lx basically stock but i have this problem that doesn't happen all of the time. I've replaced the starter solenoid (relay) 3 times!! It's stuck turning over and I have to unhook the battery. Even with the key out it still tries to turn over so its not the relay...
  7. General Mustang Tech
    I already replaced the switch because of a different issue. It's not the motor itself, I "borrowed" one to see if that made a difference with no luck. The wipers work on high and low but not intermittently a.k.a. delay. Any ideas? such as the location of the relay (there's gotta be a relay) or a...
  8. 5.0/5.8 Engine Tech
    Hey all, First post for me, but I've browsed a lot and read many a post here, even when I wasn't looking for anything in particular. Pretty amazed at the knowledge here. Anyhow...Just installed a new starter(1991 LX 5.0), yep, it was a challenge and feel a little proud with the whole top...
  9. Electronics and Entertainment
    SOLD Adjustable fan thermostat with relay Painless wiring accessories part# 30104 This kit is designed to allow a wide range of temperature adjustments for an electric fan. A bulb at the end of the capillary tube is designed to probe or be attached to the top or the hottest portion of...
  10. General Mustang Tech
    I decided to do a write-up about installing aftermarket fog lights in a Fox I have a 93 GT, it had originally came with OE fog lights (of course) which are missing. I installed aftermarket fog lamps using the O.E switch, but with a relay, so it wont melt the Headlight harness. This set up...
  11. Nitrous solenoid & Relay

    I mounted the nitrous solenoid with a bolt I bought from the hardware store, in an existing hole on the back of the firewall. Also, mounted the ground wires from the solenoid and fuel pressure safety switch right next to it. Also, mounted relay with a small screw into another existing hole.
1-12 of 12 Results
Top