Ford Mustang Forums banner

problems

  1. General Mustang Tech
    I decided to replace shift fork pads and blocking rings to the carbon fiber ones in my tremec 3550. All went well, was pretty cut and dry disassembly and assembly. Got transmission back in car and now 3rd and 5th seem to not fully engage. They will pop out of gear if you don't hold pressure...
  2. 5.0/5.8 Engine Tech
    I mocked up my drivetrain and found the pass side collector hitting the floor board. Driver side looks fine. When I measure the collector height from the ground, the pass side sits up 1" higher, which is causing the floor board interference. The headers are 1 3/4 Mac longtubes on a 351w with...
  3. 5.0/5.8 Engine Tech
    Doing a hci swap on my 89 gt. Trick flow 170s, stage 1 came, trick flow valve train, performer 5.0 intake. My problem is the intake gaskets wernt matching with the intake ports the way i would like them to. (Fel-1250) im real particular and its not off by much, but if it has any problems in the...
  4. 5.0/5.8 Engine Tech
    To anyone who can help, just got done with building my 95. To make a long story short, just did all this work, first time cranking after makeing the swap from my fox to my 95. Turn the key, and with in 10 sec the motor is wanting to start, with little pop, try it again, and another 10 sec the...
Top