Ford Mustang Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-13 of 13 Results
  1. SVO/2.3L
    I just got my 86 SVO running again after sitting for a few years. I installed an aluminum drive shaft years ago. One thing I forgot about was the terrible vibration / noise on deceleration when in gear. It does not do it on acceleration. Noise appears to be coming from the tail of the...
  2. SVT & DOHC
    Hey guys, I've got some strange noises coming from my mach and I'm not sure exactly whats going on with it. For reference the car has 118,XXX miles on it and has extensive mods done to it. Notably a D1SC procharger with >5k miles on it. The noise seems to appear at 1.8-2.2k rpm and sounds like...
  3. General Mustang Tech
    Hey everyone, just rebuilt my 8.8 rear end on my 2000 mustang gt after noticing an oil leak from the pinion seal. Went ahead and put 3.73 gears in from the stock 3.27s. Replaced all the bearings and used the original shims from the stock gears. Backlash was set properly. Put everything back...
  4. General Mustang Tech
    Hi forum, I bought a 2003 model 12 month ago with 110k miles. It has 130k now and I got a new clutch 3 or 4 months ago (still got warranty on the part). A few days ago the car started to make a loud high pitched squeaky noise, literally over night. The sound appears when I as much as touch...
  5. GT & SOHC
    Hi All, I've been trying to pin down a chirping / squeaking noise on my 02 Auto GT to no avail. The chirping sound has a high pitch and rotating frequency. Similar to the sound of pulley bearing gone bad. The only time the noise appears is for about the first 30 seconds or half mile drive...
  6. GT & SOHC
    So, I built a 5.4 and swapped it into my 2000 GT and it has a rattle that 3 shops so far can't diagnose. It's a strange one, seems to be coming from passenger side, is notable on cold start then when warmed up you can only hear it when the windows are up and everything is off , luckily it's not...
  7. 94/95 Tech
    Hey there, First off, I freakin' love the 5.0! That said, I'm not sure if I remember my old 88 5.0 being as loud under the hood as my current engine. If you kind folks could spare a few seconds to click this video, skip to about 1 minute in, and tell me if it sounds normal or a bit too loud...
  8. GT & SOHC
    ok guys, my 96 has an issue... its been pinging alot lately, but always has if i didnt run premuim. well tuesday after noon, i drove to dr about an hour away, all kinds of speed, normal 70mph interstate driving. well, went to leave, car crunk fine then immediately stalled. i was suprised bc this...
  9. 5.0/5.8 Engine Tech
    So i got in my car today.... let it warm up for the average 5 mins... took it down the block got up to 1600 rpm and then.... a slight grinding noise but it was high pitched... this precedes to happen from about 1600-2000 rpm in every gears and does not get louder or faster. Im going on a 150mile...
  10. GT & SOHC
    Hello everyone, I know this is a long post but I would really appreciate if you guys took the time to read this over, it's a problem I've been trying to diagnose for almost a year now. I've had a pretty distressing noise coming from my mustang since I purchased the vehicle. The best way I can...
  11. General Mustang Tech
    Hi All, Car: 1992 GT Motor: 5.0 Trans: T5 So the noise I'm hearing is kind of a 'whining' type of noise from my drivetrain. Definitely not a squeal or a squeak. Almost like the noise your trans makes when going into a gear with worn syncros. See below for when it happens. I'm leaning toward...
  12. General Mustang Tech
    my cats were rattling around 1000-1500 rpm in my 93 5.0 with aftermarket exhaust it sounded like there was rocks in it so i took out my exhaust (all ####in 1 piece) and tilted it upward and banged on it and a few little white bit fell out and some white dust and now im wondering should i just...
  13. 94/95 Tech
    ok so i have a 95 gt 5L with a 5 speed t55 tranny short shifter, edelbrock upper and lower intake, and lots of other crap like roller rockers and gt40 heads etc. etc. one day i started my car and it started to make a grinding noise constantly. i did not know what it was so i kept driving it...
1-13 of 13 Results
Top