Ford Mustang Forums banner

imrc

  1. Modular Engine Parts
    SOLD ON EBAY!
  2. Modular Engine Parts
    SOLD!
  3. Modular Engine Parts
    Looking for a working imrc controller from a 96-98 cobra you can text me or reach me on here. 518-844-4202 Thanks in advance, Trevor
  4. Modular Engine Parts
    I am selling a brand new set of Ford Intake manifold runner control plates.These have been dicontinued by Ford. Here is your chance to replace your plates with new parts instead of using an old set with worn bushinds.Don't delete em,replace em!!Thanks $250 shipped
  5. Modular Engine Parts
    Brand new 96-98 Cobra/Mark imrc plates.I bought these a few years agao and never needed them.Impossible to find BRAND NEW!$250 shipped!! The photo dates are default on my camera sorry.I just took them! 814 790-5236
  6. SVT & DOHC
    I'm looking to buy a IMRC controller box, Ford P/N F6ZZ-9J559-BB for a 1996 Cobra. There are some on Ebay, but came from a 97-98 Lincoln Mark VIII, not sure these will actually work (can't find a definitive answer if the parts are actually the same). I did find a post from 2003 on svtperformance...
  7. Modular Engine Parts
    Parts are from a 1997 Mark viii engine with 23k miles Just a little dirty but in very good condition. IMRC plates with wires and module- $60 shipped. Upper lower intake manifold w/ tb - Make offer. Upper and Lower Intake with Tb. IMRC's with Module
  8. Modular Engine Parts
    SOLD! IMRC plates removed from 96 Cobra. STOCK. $40. SOLD!
  9. Modular Engine Parts
    I am going to attempt to upgrade my 1994 Lincoln Mark VIII intake manifold IMRC setup. Well, my friend will be doing it because I'm not very mechanically inclined yet. I'm trying to become familiar with the process so I can help and also make sure I have everything for the project. I have the...
  10. imrc b4 & after

    imrc b4 & after

    you can see the diff. between the imrc's before top, after- bottom. And just so this dosent happen again, im going to run a catch can and vent to atmosphere both valve covers/pvc, and put a restrictor on the egr inlet on the plenum. plus you should run the pcv with boost anyway.
    • 570cobra96svt
    • Media item
    • Comments: 0
    • Album: REAR turbo 96 cobra project
  11. imrc porting

    imrc porting

    you can see, i pulled the imrc's out, they were still working, but they def. had to be clean'd and i notice'd that they dont realy line up with the gasket or plenum good, so i port mathc'd them, and i did notice a little bit better smoothness in part throttle.
    • 570cobra96svt
    • Media item
    • Comments: 0
    • Album: REAR turbo 96 cobra project
Top