Ford Mustang Forums banner
head gasket
1-10 of 11 Results
  1. Six Shooter
    Hi All, I have a huge coolant leak which seems to be coming from the area behind and a little below the EGR valve. It's not the water pump, it's around the top part or even further above the timing cover. Even when idling the coolant leaks profusely, to create a puddle within 10-15 mins. The...
  2. 5.0/5.8 Engine Tech
    Need Help.. Which head gaskets for a boosted 331??? I am finally working on finishing my 331 project motor and need to buy some head gaskets to move on. I wanted the wonderful opinions of this great forum to see what the best options are for my application. Thanks in advance. Here are the...
  3. GT & SOHC
    The inlet heater hose keeps blowing. Possible cause: 1. I have a 7.5 inch lower pulley that spins everything faster than factory including the water pump. This could cause the water pump to push to much water??? 2. A leaky intake manifold gasket. This could cause the air from the blower (16...
  4. 5.0/5.8 Engine Tech
    Never noticed a leak until the other day. This is what I'm seeing on the passenger side floorpan near the cat. Any advice as to where to begin looking would be greatly appreciated. (It's a 93 5.0 LX w/77k and I dropped the tranny a couple weeks ago to replace the clutch if that means...
  5. Windsor Engine Parts
    Two brand new, still in the new packages, C5479-060 Cometic small block Ford head gaskets. These are listed as Yates head gaskets, but will also work on convensional SBF heads. I ran them with TFS R heads on an R302 block with great success. My new combo can't use these and I've sold off all the...
  6. GT & SOHC
    i have a 96 gt with 79k on it. i was trying to sell the car but then realized it had bad valves seals because i saw oil burning when i reversed into the wind. so i decided to take the heads off and found a few interesting things i had some qeuestions about. first question is on my head gasket...
  7. 5.0/5.8 Engine Tech
    looking at a set for my new 302 build to kinda up the compression a bit are they worth looking at most VWs run them and if put on a car that dont call for it (mk3 VR6) the gasket will add half a point of compression..(10:1 to 10.5:1) are they reliable?? same for copper header gaskets are they...
  8. Windsor Engine Parts
    Power Adder Solutions,Inc. is a Proud Distributor for Trick Flow Specialties. Trick Flow Twisted Wedge Track Heat 190cc Cylinder Heads TFS-51400015 Please Post/PM For Priceing. We look forward to hearing from you!! Thanks, [email protected],Inc. PowerAdderSolutions.com, Ford Mustang Performance...
  9. Windsor Engine Parts
    Complete set (2), never used. $50 shipped FORD SBF Heads Gaskets V8 260, 289, 302, 351W 1962-95 ROL Racing Part number: HG32841HR Bore size: 4.115" Normal compressed thickness: 0.039" Approx. Compressed volume: 8.5cc Material construction: GRAPHITE W/STEEL CORE & STAINLESS STEEL FIRE RING...
  10. Are the head gaskets installed correctly?

    Visual inspection tip to figure out if head gaskets are installed correctly after assembly.
1-10 of 11 Results
Top